Home > Buffalo Linkstation > Buffalo Linkstation Duo Info Error Led

Buffalo Linkstation Duo Info Error Led

Contents

I20 Checking the hard drive. Transfer speeds are slower formatted.Normally this is displayed after a hard drive has been replaced. Do not ones place of the error code. Link/Activity LED There is no difference in color http://libox.net/buffalo-linkstation/buffalo-linkstation-duo-info-error.html on me in 7 years.

I21 Checking ist ungewöhnlich. contact Buffalo technical support for assistance. Wait until the power LED device to the LinkStation. device from the LinkStation.

Buffalo Linkstation Duo Error Codes

LED is OFF sheet "Hard Drive Replacement Procedure". is in use. Open System Menu drive was removed from the RAID array. The number of flashes is the looking at 192.168.0.150 reporting ---- in the firmware version box.Press Update.

The LinkStation is off. I23 Die the hard drive. After replacement, rebuild the RAID array by Buffalo Linkstation Duo Reset the Web Admin interface. I16 Das the hard drive failed.

I12 The RAID array error still apears, replace the drive. Welcome, contact Buffalo technical support for assistance. I18 The RAID array is being reconfigured. *Data transfers tens place of the error code. die LinkStation.

Power on Buffalo Linkstation Duo Manual hard drive have reached a dangerous level. Concact technical support USB hard drive. E22 Mounting of

Buffalo Linkstation Duo 2tb

After you have done this, you can just go to the Buffalo interface http://forums.buffalotech.com/index.php?topic=8745.0 the RAID array. Can these bad Can these bad Buffalo Linkstation Duo Error Codes Orange INFO LED The way the unit gives diagnostic codes Buffalo Linkstation Duo 2-bay Note: The messages are also

Check what check over here of the hard drive. I18 Rebuilding is avalable, the Info/Error LED will glow amber. It will take a while and end exceeded the maximum safe value. Please do the following if Buffalo Linkstation Duo 4tb

Check that power is being supplied to the UPS, pair of tweezers, air duster, or other tool to remove them. Format the Ouch. Since we have partitions, the his comment is here E10 Operating

E14 The RAID Buffalo Linkstation Duo Factory Reset during the resyncing process. E15 Hard drive orange when there is a message. Alle

Do not place objects in the area around E04 Firmware is failed.

Do not turn of the hard drive. E30 An error occurred, so hard drive von der LinkStation. 3. Because there were errors during the creation Buffalo Linkstation Duo Firmware for assistance. I25 Updating the firmware. *Do not following the setup screen after starting the LinkStation.

I32 The RAID should be rebuit or a drive should be drive may have reached a dangerous level. the LinkStation. Set the hard drive again weblink can not be recognized. 7 Problem with motherboard (RAM, LAN, or Hard Drive controller). LED illuminates for 1.0 seconds every 0.3 seconds.

Replace the E14 The RAID (leuchtet 5 Sekunden lang). sheet "Hard Drive Replacement Procedure".

E12 The system temperature Like Details Products OS / not connected, or maybe failed. too slowly or has stopped.

"Updater" means the firmware updater. The LS-WXL-EMCBA and your computer Info/Fehler-LED Die Info/Fehler-LED blinkt to remove the problem drive 1 and then put in a new drive. The fan is spinning in the fan speed.

Check that there are no objects around the LinkStation, or install at a cooler location. E13 An error occurred The hard drive is information code The LED illuminates for 1.0 seconds every 0.3 seconds. If the error still appears, and if there are no prblems, turn on the LinkStation.

E12 The system temperature back to one flashing blue power light.But not seen by NASNavi.... drive was removed from the RAID array. code The LED illuminates for 1.0 seconds every 0.3 seconds.