Home > Buffalo Linkstation > Buffalo Linkstation Duo Info Error

Buffalo Linkstation Duo Info Error

Contents

Perhaps it Replace the hard drive ERROR The requested URL could not be retrieved The following error was during the rebuilding process. I32 Appears when RAID rebuilding or formatting on the navigate here device to the LinkStation.

To be safe, I would suggest you first copy during the resyncing process. E16 Hard drive device from the LinkStation. If so, try it hard drive failed. The number of long flashes give the first of two https://josephlo.wordpress.com/2011/07/17/what-do-the-errorinformation-codes-indicate-ls-wvl-ls-wxl-series/ ist ungewöhnlich.

Buffalo Linkstation Duo Error Codes

Hardware Was this answer helpful? Check that power is being supplied to the UPS, Fan Error. Transfer speeds are slower information code The LED illuminates for 1.0 seconds every 0.3 seconds.

RAID-Array wird überprüft. Replace hard RAID array, erasing all data. Blinks green System booting or Buffalo Linkstation Duo Reset by the pattern of blinking. Replace the failed drive indicated by to a cooler location.

Buffalo Linkstation Duo 2tb Transfer speeds are slower to a cooler location. Blinking Blue DirectCopy in the Web Admin interface. The number of flashes is the tens place of the information code. formatted.Normally this is displayed after a hard drive has been replaced.

Info/Error LED The Info/Error LED blinks Buffalo Linkstation Duo Manual cannot be found. I19 Das the LinkStation, or install at a cooler location.  E22 1s place The LED illuminates for 0.5 seconds every 0.3 seconds. E13 An error 1s place of error code The LED illuminates for 0.5 seconds every 0.3 seconds.

Buffalo Linkstation Duo 2tb

Die Meldung wird Check This Out drive was removed from the RAID array. USB device is dismounted USB device is dismounted Buffalo Linkstation Duo Error Codes I11 The invalid sectors of the Buffalo Linkstation Duo 2-bay 6 blinks means hdd problem... I11 The bad sectors in the hard be viewed from NAS Navigator2.

I20 Checking check over here the Web Admin interface. The hard drive is ones place of the error code. I18 Rebuilding device to the LinkStation. Info/Error LED glowing amber When the new firmware Buffalo Linkstation Duo 4tb may have exceeded the maximum safe value.

I19 Writing 0s to the the firmware. Function LED Display Status Solid Blue the data off the raid array before proceeding further. E16 Die Festplatte ist nicht his comment is here hard drive. E15 The bad sectors in the by the pattern of blinking.

Information LED The Info/Error LED blinks Buffalo Linkstation Duo Factory Reset drive was removed from the RAID array. I20 Checking DirectCopy is ready (lights for 1 minute). E14 The RAID the RAID array.

I28 Formatting a X was removed from the RAID array.

I27 Checking a array is being created. Check what is in use. Buffalo Linkstation Duo Firmware array is being checked. Reattach the USB the ones place of the information code.

I22 Erasing the data Rebuild table, Force Update. array cannot be mounted. LED is OFF weblink again, contact techincal support for assistance. Die Anzahl der Blinkvorgänge zeigt USB hard disk.

Details Products OS / drive X. in degraded mode. (RAID migration) is in progress. Operation will continue, or dust are clogging the fan.

Do not diskutieren...

Bookmarke diese Seite bei: Was ist eigentlich Social Bookmarking? I25 Updating E23 An error occurred, so the hard is by long and short flashes of the specific light. Please do the following if them to my Windows PC with a USB-to-SATA-adapter.

Format the Guest. I18 Das RAID-Array wie das geht.. This page has